This Is How I Fixed The Air Injection Switching Valve.
Search by keywords, part numbers or full vin go. I would suggest you replace it yourself as it would cost you about$360.00 if you were to. Shop 2008 toyota tundra secondary air injection pump hose.
Most Of The Time, P0410 Is Going To Be Caused By A Failure In This Pump Or The One Way Check Valve.
Obviously, this is a major concern for any 2007 and older tundra owner. When the air system is active, then air pump forces fresh air into the exhaust stream in order to accelerate catalyst operation. But there can be other reasons the code is thrown as well.
Shop 2008 Toyota Tundra Secondary Air Injection Pump Hose.
The 2008 toyota tundra has 6 problems reported for air injection system failure. Both are located in the engine compartment fuse box under driver side fender next to the battery. The air combination valves replace the conventional check valves.
If You Happen To Live In A State Which Requires Emissions Testing, You Will Fail The Test If.
Most of the time, p0411 is going to be caused by a failure in this pump or the one way check valve. It is about the size of a baseball and has two hoses going intoit. My 2007 toyota tundra went into limp mode when multiple dash warning lights came on.
The Pumps And/Or Valves Seem To Be Malfunctioning At About The Same Time That Toyota’s 3 Year/36K Mile Warranty Ends, Sometimes At A Total Cost Of More Than $4,000.
Secondary air injection pump hose. P2440 secondary air injection switching valve stuck open. The pcm enables both circuits simultaneously when air system operations id desired.