2010 Toyota Tundra Camshaft Position Sensor Location

We Offer A Full Selection Of Genuine Toyota Tundra Camshaft Position Sensors, Engineered Specifically To Restore Factory Performance.

The ecm relies in the cam and crank sensors. This information is used by the engine control module to control ignition and fuel injection. I have checked the connectors for seat and looked at the wires on both sides and seating but still getting the code below.

The Camshaft Position Sensor Senses The Retraction Of The Camshaft (Intake) To Identify A Particular Cylinder.

If is in about the center of the block. Hope this works as i did a screen shot of where i think it's at. Refer to camshaft position actuator solenoid valve replacement.

Anyway, The Cam Sensor Is Easy To Get To.

Check if this fits your 2010 toyota tundra. Momentarily touch the jumper wire to ground. If your check engine light is on as a result, our technicians can diagnose and repair the problem.

When The Tundra's Ecm Determines That There Is An Issue With The Signal Coming From This Sensor, It'll Throw The P0335 Trouble Code.

If you need to replace them, put all new spark plugs in too right away. Check if this fits your 2010 toyota tundra. The toyota tundra utilizes a crankshaft position sensor in order to regulate the engine timing.

I Would Check The Coils And See If They Are Split (Especially #8 , Back Passenger Side, P0340 Is Also For A Bad Coil On #8 ).

Fast forwarding, the code was p0355 for the crankshaft position sensor. Connect a jumper wire to the cmp actuator low reference circuit terminal b at the solenoid. If one or the other is really out/bad you wouldn't be able to start your truck.