This Trailer Brake System Connector Is Built To The Highest Standards Of The Rv Industry And Will Last A Long Time.
I have a different style just because i already had it. They cost about $150 or so. Looks like the other thread was closed and i'm not looking to start a debate.
Connector Plugs Directly Into Tow Vehicle
This system allows you to sync up the brakes of a trailer equipped with electric brakes, to the braking system of the tundra pickup. Reduce your brake control installation time to minutes! I contacted our representative at tekonsha and he informed me that the plug should be located under the dash to the left of the brake pedal or behind the kick panel.
In the 2015 tundra which takes a different adaptor cable, the truck plug is to the right of the steering wheel. I bent up a bracket that bolted the controller to the to the studs The 3040 harness only works with '03 and newer tundras because it's designed to plug into the oem brake controller interface plug behind the kick panel on the '03s (and newer).
The Plug On The Truck Is On The Left Side Under The Side Panel And You Typically Locate The Controller To The Right Of The Steering Wheel.
'05 4x4 dc lb sr5 (lsd & tow pkg), timbrens, aal, 5100s (.85), front diff drop, owned: It will control up to 4 axles or 8 brakes. In addition, take your truck to the dealer and have them open a case.
2) Remove Screw Type Clip Holding Cover.
There is a connector that you use, seems pretty straight forward if you look at the diagram. Connector harness under the dash. You can check out the attached photo that shows where this panel is located.
