Take A 1 Piece Of Black Electrical Tape And Put It Over The Small Square Under The Vinyl Backing To Block The Light From The Tpms Sensor Warning Lamp.
The tape is right at the end of my finger in place under the vinyl backing. Then release the reset button. Posted on mar 24, 2010
Turn Off The Ignition Switch After About Five Minutes So The System Has Time To Initialize Completely.
With the vehicle off, turn the key to the “on” position, but do not start it. Wait for several minutes with the engine switch in the “on” position, to allow the system to record each tire’s pressure, then turn the engine off. Hold down the tire pressure reset button under your steering wheel until you see the light flash three times.
Each Model Year Has A Different Button Location.
Hopefully, these steps can help you reset the tire pressure light in. Click “set/reset” and a message saying “tire learning active” will pop up. With the vehicle off, do not start the car, but turn the key to the “on” position.
Turn The Key Off, Then To On.tpms Warning Symbol Should Come On, Then Go Off After About 2 Seconds.
Turn the engine switch to the “on” position. Find and press the tire pressure warning reset button and wait for the moment when the light blinks 3 times. Hold the tpms reset button until the tire pressure light blinks three times, then release it.
The Tpms Reset Button Is Usually Located Beneath The Steering Wheel.
If the warning light comes on, stop your vehicle in a safe place as soon as possible and check that the inflation pressure of all tires (including the spare tire) is as specified on the tire and loading information label. Resetting the system allows the tundra to accurately measure the air pressure in all of the tires. If the warning light blinks, the tire pressure warning system may be malfunctioning.
