Toyota Tundra Door Handle Replacement Instructions

Connect The Door Handle And Lock Cables.

I'm trying to repair a broken outside door handle on my 2001 camry and ran into some problems. Move to the bottom of the door and begin to pull the panel out toward you. Recently, the outside door handle partially broke off when i opened the driver door of my 2001 camry.

Tighten The Phillips Screw To The Door Pull.

Remove the locking part of the door handle from the outside. Clip the weather seals into place. Use a phillips screw driver to remove the screw located in the close door assist handle pull up on the close door assist handle to remove it step 4 (rear doors):

Press On The Trim Clip To The Door Panel.

Set of 4 replaces oe number : Front, driver and passenger side notes : Remove the screws that fasten the interior door panel to the door.

Fits Models With Manual Door Locks Components :

(2) exterior door handles, and (2) interior door handles color finish : Lift the door panel on. Tundra trd parts installation instructions:

Chances Are Also High That They’re Damaged.

There will be two cables that connect the handle and lock button to the door lock assembly. Take the door handle and then slide it into place. Below is the step by step instructions: