May 08, 2011 • 2008 chevrolet avalanche. While it is possible, it seems unlikely that three door lock actuators would go bad at the same time, right? A connector accessible only by removing the circuit board had an intermittent connection.
Does Anyone Know Where The Door Lock Fuse And/Or Relays Is Located?
Aside from its inconvenient location, the most difficult part of removal is due to the amount of wiring running to/from the box and how tight the wiring is. In our material you will find information with the location of electronic control units, a description of fuses and relays toyota tundra with box diagrams and photo examples of execution. If any of the electrical components do not operate, a fuse may have blown.
I Simply Responded, Just Press.
While removing the panel, make sure to find and unhook the electrical cable that attaches to the door handle on the inside. Using a diagram, locate the door lock relay. I replace the door control panel.
Remove The Door Panel By Finding Screws On The Exterior Of The Panel And Armrest.
After removing the panel on the back of the fuse box, i carefully pried out the circuit board and sprayed contact cleaner on the connector. The main fuse box under the hood on the driver side has a power lock relay but i don’t see one for power window relay. The window motor works, switch works, i can only think of a fuse or relay thats bad but i don’t know where the window relay is located.
See More On Our Website:
To get started, enter the vehicle and close all doors. In this article you will find a description of fuses and relays toyota, with photos of block diagrams and their locations. Check the purpose of the elements with your diagrams on the box cover.
