1)Roll Back The Two Vents In The Bezel, Look Closely And There Is A Phillips Head Screw On The Upper Side Of Each One, Thats (2) Screws.
3) remove the cup holders by pulling them upward. 08 silver crewmax 5.7 4x4 sr5. U will need to pull the radio out of the dash and remove the top cover of the radio chassis, under that cover there is a tiny light bulb in a little socket that twists into the back of the dial display, the bulb looks like a miniature peanut, this is the back light for the radio display, u can buy the bulb at any full service parts store or at the dealer, about $1
Get A Small Flat Blade Screw Driver And (I Suggest Putting Some Electrical Tape On The Tip) Slide It In Under The Bottom Of Your Silver Bezel That Is Around The Radio And Ac Controls.
2) pull out the ashtray and then remove the center cover. You will need a long tapered/pointed bit. Reach under the head unit and gently wiggle it until it comes loose.
2)Take Off The Three A/C Control Knobs, There Is A Screw Behind Each, Thats (3) Screws.
Broken antennas are more common than you might think, and they always seem to. Asked by bfulda in manahawkin, nj on january 08, 2010. 2007 toyota tundra radio removal.
Drop The Dash Under The Steering Wheel.
I would like to replace the indash radio with a nav system. Try using a dremel or similar tool to grind a small slot in the top so you can use a small screwdriver to remove the stub. It might take a little force to release the yellow tabs holding the.
You Also Need To Pull The Knobs Off And There Are Another 3 Screws (One Behind Each Knob) That Need To Be Removed, Then It Will Just Pull Out.
Cargurusfrustrated2000tundra asked a 2000 toyota tundra 2 dr sr5 v8 4wd standard cab lb maintenance. Would like any info about removing the dash panel (s) in order to complete removal and install. Reach under the climate control area and gently pull forward to remove it.
